p300

In order to stabilize cams, springs, and linkages within the fuel control, manufacturers generally recom- mend that all final turbine engine trim adjustments be made in the

发布于 2021-02-16 21:54:27

【单选题】
A increase direction.
B decrease direction.
C decrease direction after over-adjustment.

关注者

0

被浏览

84

一樽还酹江月 2023-02-16

生命就是抗争

此回答被采纳为最佳答案，开通VIP会员可查看

1 个回答

撰写答案

请登录后再发布答案，点击登录

关于作者

新年

这家伙很懒，什么也没写！

提问

回答

1249

被采纳

1249

关注TA

发私信

相关问题

1

Airflow to the pneumatic starter from a ground unit is normally prevented from causing starter overspeed during engine start by

2

A safety feature usually employed in pneumatic starters that is used if the clutch does not release from the engine drive at the proper time during start is the

3

A safety feature usually employed in direct-cranking starters that is used to prevent the starter from reaching burst speed is the

4

In the event a pneumatic start valve will not oper- ate and the manual override must be used, the starter Thandle must be closed at scheduled starter drop out because

5

What factor is not used in the operation of an air- craft gas turbine engine fuel controi unit?

6

全部试验时，旅客列车和特快货物班列自阀减压50kPa并保压（　）min，对列车制动机进行感度试验.。

7

When trimming a turbine engine, the fuel control is adjusted to

8

A supervisory electronic engine control (EEC) is a system that receives engine operating information and

9

A full-authority electronic engine control (EEC) is a system that receives all the necessary data for engine operation and

10

In a supervisory EEC system, any fault in the EEC that adversely affects engine operation

发布
问题

手机
浏览

扫码手机浏览

在线
客服